Henry.joshua: Created page with "Category:Email Configuration and Setup =Microsoft Outlook 2010= When you open Outlook, it will look like this: File:outlook 2010 1.PNG Click on File: [[File:outlook ..."

2012-06-10T03:43:08Z

Created page with "Category:Email Configuration and Setup =Microsoft Outlook 2010= When you open Outlook, it will look like this: File:outlook 2010 1.PNG Click on File: [[File:outlook ..."

New page

[[Category:Email Configuration and Setup]]

=Microsoft Outlook 2010=

When you open Outlook, it will look like this:

[[File:outlook 2010 1.PNG]]

Click on File:

[[File:outlook 2010 2.PNG]]

To add a new account click Add Account. Enter your email address and password:

[[File:outlook 2010 3.PNG]]

Select the Manually configure server settings or additional server types and click Next.

[[File:outlook 2010 4.PNG]]

Select Internet E-mail and click next.

[[File:outlook 2010 5.PNG]]

Fill out the incoming and outgoing servers and enter your username(full email address) and password. Then click More Settings...

[[File:outlook 2010 6.PNG]]

Go to the Outgoing Server tab and select the My outgoing server (SMTP) requires authentication box. Select Use same settings as my incoming mail server.

[[File:outlook 2010 7.PNG]]

Now go to the Advanced tab and make sure Incoming is set to 110 and outgoing is set to 25. The This server requires an encrypted connection (SSL) box should NOT be checked. The drop down for Use the following type of encrypted connection: should say None. Then click OK.

[[File:outlook 2010 8.PNG]]

Outlook will test the settings for you:

[[File:outlook 2010 9.PNG]]

Click close and then click Finish:

[[File:outlook 2010 10.PNG]]

You should now be able to send and receive mail.

[[File:outlook 2010 11.PNG]]

If you need to check an existing account, navigate to the File tab and click Account Settings:

[[File:outlook 2010 12.PNG]]

Highlight the email account you want and click Change...

[[File:outlook 2010 13.PNG]]

Verify the incoming and outgoing servers are set up and the User Name is your full email address. Then click More Settings...

[[File:outlook 2010 6.PNG]]

Go to the Outgoing Server tab and verify the My outgoing server (SMTP) requires authentication box is selected. Select Use same settings as my incoming mail server.

[[File:outlook 2010 7.PNG]]

Now go to the Advanced tab and make sure Incoming is set to 110 and outgoing is set to 25. The This server requires an encrypted connection (SSL) box should NOT be checked. The drop down for Use the following type of encrypted connection: should say None. Then click OK.

[[File:outlook 2010 8.PNG]]

Outlook 2010 - Revision history

Henry.joshua: Created page with "Category:Email Configuration and Setup =Microsoft Outlook 2010= When you open Outlook, it will look like this: File:outlook 2010 1.PNG Click on File: [[File:outlook ..."